kernel/git/stable/linux-stable.git/drivers/net/mdio, branch linux-6.15.y

net: mdio: mdio-bcm-unimac: Correct rate fallback logic

2025-08-15T10:16:59+00:00

[ Upstream commit a81649a4efd382497bf3d34a623360263adc6993 ] When the parent clock is a gated clock which has multiple parents, the clock provider (clk-scmi typically) might return a rate of 0 since there is not one of those particular parent clocks that should be chosen for returning a rate. Prior to ee975351cf0c ("net: mdio: mdio-bcm-unimac: Manage clock around I/O accesses"), we would not always be passing a clock reference depending upon how mdio-bcm-unimac was instantiated. In that case, we would take the fallback path where the rate is hard coded to 250MHz. Make sure that we still fallback to using a fixed rate for the divider calculation, otherwise we simply ignore the desired MDIO bus clock frequency which can prevent us from interfacing with Ethernet PHYs properly. Fixes: ee975351cf0c ("net: mdio: mdio-bcm-unimac: Manage clock around I/O accesses") Signed-off-by: Florian Fainelli Reviewed-by: Andrew Lunn Reviewed-by: Simon Horman Link: https://patch.msgid.link/20250730202533.3463529-1-florian.fainelli@broadcom.com Signed-off-by: Jakub Kicinski Signed-off-by: Sasha Levin

net: mdio: mux-meson-gxl: set reversed bit when using internal phy

2025-04-29T19:01:53+00:00

This bit is necessary to receive packets from the internal PHY. Without this bit set, no activity occurs on the interface. Normally u-boot sets this bit, but if u-boot is compiled without net support, the interface will be up but without any activity. If bit is set once, it will work until the IP is powered down or reset. The vendor SDK sets this bit along with the PHY_ID bits. Signed-off-by: Da Xue Fixes: 9a24e1ff4326 ("net: mdio: add amlogic gxl mdio mux support") Link: https://patch.msgid.link/20250425192009.1439508-1-da@libre.computer Signed-off-by: Jakub Kicinski

net: mdio: mdio-i2c: Add support for single-byte SMBus operations

2025-03-25T16:10:55+00:00

PHYs that are within copper SFP modules have their MDIO bus accessible through address 0x56 (usually) on the i2c bus. The MDIO-I2C bridge is desgned for 16 bits accesses, but we can also perform 8bits accesses by reading/writing the high and low bytes sequentially. This commit adds support for this type of accesses, thus supporting smbus controllers such as the one in the VSC8552. This was only tested on Copper SFP modules that embed a Marvell 88e1111 PHY. Tested-by: Sean Anderson Signed-off-by: Maxime Chevallier Reviewed-by: Andrew Lunn Link: https://patch.msgid.link/20250322075745.120831-3-maxime.chevallier@bootlin.com Signed-off-by: Jakub Kicinski

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2024-12-19T19:35:07+00:00

Cross-merge networking fixes after downstream PR (net-6.13-rc4). No conflicts. Adjacent changes: drivers/net/ethernet/renesas/rswitch.h 32fd46f5b69e ("net: renesas: rswitch: remove speed from gwca structure") 922b4b955a03 ("net: renesas: rswitch: rework ts tags management") Signed-off-by: Jakub Kicinski

net: mdiobus: fix an OF node reference leak

2024-12-19T10:45:42+00:00

fwnode_find_mii_timestamper() calls of_parse_phandle_with_fixed_args() but does not decrement the refcount of the obtained OF node. Add an of_node_put() call before returning from the function. This bug was detected by an experimental static analysis tool that I am developing. Fixes: bc1bee3b87ee ("net: mdiobus: Introduce fwnode_mdiobus_register_phy()") Signed-off-by: Joe Hattori Reviewed-by: Andrew Lunn Link: https://patch.msgid.link/20241218035106.1436405-1-joe@pf.is.s.u-tokyo.ac.jp Signed-off-by: Paolo Abeni

net: simplify resource acquisition + ioremap

2024-12-07T01:28:34+00:00

get resource + request_mem_region + ioremap can all be done by a single function. Replace them with devm_platform_get_and_ioremap_resource or\ devm_platform_ioremap_resource where res is not used. Signed-off-by: Rosen Penev Reviewed-by: Vincent Mailhol # sja1000_platform.c Link: https://patch.msgid.link/20241203231337.182391-1-rosenp@gmail.com Signed-off-by: Jakub Kicinski

net: mdio-ipq4019: add missing error check

2024-11-26T10:01:39+00:00

If an optional resource is found but fails to remap, return on failure. Avoids any potential problems when using the iomapped resource as the assumption is that it's available. Fixes: 23a890d493e3 ("net: mdio: Add the reset function for IPQ MDIO driver") Signed-off-by: Rosen Penev Reviewed-by: Andrew Lunn Link: https://patch.msgid.link/20241121193152.8966-1-rosenp@gmail.com Signed-off-by: Paolo Abeni

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2024-10-21T07:14:18+00:00

Cross-merge networking fixes after downstream PR (net-6.12-rc4). Conflicts: 107a034d5c1e ("net/mlx5: qos: Store rate groups in a qos domain") 1da9cfd6c41c ("net/mlx5: Unregister notifier on eswitch init failure") Signed-off-by: Paolo Abeni

net: phy: mdio-bcm-unimac: Add BCM6846 support

2024-10-16T01:23:53+00:00

Add Unimac mdio compatible string for the special BCM6846 variant. This variant has a few extra registers compared to other versions. Suggested-by: Florian Fainelli Link: https://lore.kernel.org/linux-devicetree/b542b2e8-115c-4234-a464-e73aa6bece5c@broadcom.com/ Signed-off-by: Linus Walleij Link: https://patch.msgid.link/20241012-bcm6846-mdio-v1-2-c703ca83e962@linaro.org Signed-off-by: Jakub Kicinski

net: mdio: Switch back to struct platform_driver::remove()

2024-10-04T23:39:57+00:00

After commit 0edb555a65d1 ("platform: Make platform_driver::remove() return void") .remove() is (again) the right callback to implement for platform drivers. Convert all platform drivers below drivers/net/mdio to use .remove(), with the eventual goal to drop struct platform_driver::remove_new(). As .remove() and .remove_new() have the same prototypes, conversion is done by just changing the structure member name in the driver initializer. Signed-off-by: Uwe Kleine-König Reviewed-by: Andrew Lunn Link: https://patch.msgid.link/0b60d8bfc45a3de8193f953794dda241e11032a9.1727949050.git.u.kleine-koenig@baylibre.com Signed-off-by: Jakub Kicinski