kernel/git/stable/linux.git/arch/arc, branch linux-5.8.y

arc: plat-hsdk: fix kconfig dependency warning when !RESET_CONTROLLER

2020-10-29T09:07:53+00:00

[ Upstream commit 63bcf87cb1c57956e1179f1a78dde625c7e3cba7 ] When ARC_SOC_HSDK is enabled and RESET_CONTROLLER is disabled, it results in the following Kbuild warning: WARNING: unmet direct dependencies detected for RESET_HSDK Depends on [n]: RESET_CONTROLLER [=n] && HAS_IOMEM [=y] && (ARC_SOC_HSDK [=y] || COMPILE_TEST [=n]) Selected by [y]: - ARC_SOC_HSDK [=y] && ISA_ARCV2 [=y] The reason is that ARC_SOC_HSDK selects RESET_HSDK without depending on or selecting RESET_CONTROLLER while RESET_HSDK is subordinate to RESET_CONTROLLER. Honor the kconfig menu hierarchy to remove kconfig dependency warnings. Fixes: a528629dfd3b ("ARC: [plat-hsdk] select CONFIG_RESET_HSDK from Kconfig") Signed-off-by: Necip Fazil Yildiran Signed-off-by: Vineet Gupta Signed-off-by: Sasha Levin

ARC: [plat-hsdk]: Switch ethernet phy-mode to rgmii-id

2020-09-17T11:55:36+00:00

[ Upstream commit 26907eb605fbc3ba9dbf888f21d9d8d04471271d ] HSDK board has Micrel KSZ9031, recent commit bcf3440c6dd ("net: phy: micrel: add phy-mode support for the KSZ9031 PHY") caused a breakdown of Ethernet. Using 'phy-mode = "rgmii"' is not correct because accodring RGMII specification it is necessary to have delay on RX (PHY to MAX) which is not generated in case of "rgmii". Using "rgmii-id" adds necessary delay and solves the issue. Also adding name of PHY placed on HSDK board. Signed-off-by: Evgeniy Didin Cc: Eugeniy Paltsev Cc: Alexey Brodkin Signed-off-by: Vineet Gupta Signed-off-by: Sasha Levin

irqchip/eznps: Fix build error for !ARC700 builds

2020-09-17T11:55:34+00:00

[ Upstream commit 89d29997f103d08264b0685796b420d911658b96 ] eznps driver is supposed to be platform independent however it ends up including stuff from inside arch/arc headers leading to rand config build errors. The quick hack to fix this (proper fix is too much chrun for non active user-base) is to add following to nps platform agnostic header. - copy AUX_IENABLE from arch/arc header - move CTOP_AUX_IACK from arch/arc/plat-eznps/*/** Reported-by: kernel test robot Reported-by: Sebastian Andrzej Siewior Link: https://lkml.kernel.org/r/20200824095831.5lpkmkafelnvlpi2@linutronix.de Signed-off-by: Vineet Gupta Signed-off-by: Sasha Levin

ARC: show_regs: fix r12 printing and simplify

2020-09-17T11:55:34+00:00

[ Upstream commit e5c388b4b967037a0e00b60194b0dbcf94881a9b ] when working on ARC64, spotted an issue in ARCv2 reg file printing. print_reg_file() assumes contiguous reg-file whereas in ARCv2 they are not: r12 comes before r0-r11 due to hardware auto-save. Apparently this issue has been present since v2 port submission. To avoid bolting hacks for this discontinuity while looping through pt_regs, just ditching the loop and print pt_regs directly. Signed-off-by: Vineet Gupta Signed-off-by: Sasha Levin

ARC: HSDK: wireup perf irq

2020-09-17T11:55:31+00:00

[ Upstream commit fe81d927b78c4f0557836661d32e41ebc957b024 ] Newer version of HSDK aka HSDK-4xD (with dual issue HS48x4 CPU) wired up the perf interrupt, so enable that in DT. This is OK for old HSDK where this irq is ignored because pct irq is not wired up in hardware. Signed-off-by: Vineet Gupta Signed-off-by: Sasha Levin

arc: fix memory initialization for systems with two memory banks

2020-09-09T17:14:25+00:00

commit 4af22ded0ecf23adea1b26ea264c53f9f1cfc310 upstream. Rework of memory map initialization broke initialization of ARC systems with two memory banks. Before these changes, memblock was not aware of nodes configuration and the memory map was always allocated from the "lowmem" bank. After the addition of node information to memblock, the core mm attempts to allocate the memory map for the "highmem" bank from its node. The access to this memory using __va() fails because it can be only accessed using kmap. Anther problem that was uncovered is that {min,max}_high_pfn are calculated from u64 high_mem_start variable which prevents truncation to 32-bit physical address and the PFN values are above the node and zone boundaries. Use phys_addr_t type for high_mem_start and high_mem_size to ensure correspondence between PFNs and highmem zone boundaries and reserve the entire highmem bank until mem_init() to avoid accesses to it before highmem is enabled. To test this: 1. Enable HIGHMEM in ARC config 2. Enable 2 memory banks in haps_hs.dts (uncomment the 2nd bank) Fixes: 51930df5801e ("mm: free_area_init: allow defining max_zone_pfn in descending order") Cc: stable@vger.kernel.org [5.8] Signed-off-by: Mike Rapoport Signed-off-by: Vineet Gupta [vgupta: added instructions to test highmem] Signed-off-by: Greg Kroah-Hartman

ARC: perf: don't bail setup if pct irq missing in device-tree

2020-09-09T17:14:25+00:00

commit feb92d7d3813456c11dce215b3421801a78a8986 upstream. Current code inadventely bails if hardware supports sampling/overflow interrupts, but the irq is missing from device tree. | | # perf stat -e cycles,instructions,major-faults,minor-faults ../hackbench | Running with 10 groups 400 process | Time: 0.921 | | Performance counter stats for '../hackbench': | | cycles | instructions | 0 major-faults | 8679 minor-faults This need not be as we can still do simple counting based perf stat. This unborks perf on HSDK-4xD Cc: Signed-off-by: Vineet Gupta Signed-off-by: Greg Kroah-Hartman

ARCv2: support loop buffer (LPB) disabling

2020-06-18T20:07:24+00:00

On HS cores, loop buffer (LPB) is programmable in runtime and can be optionally disabled. Signed-off-by: Eugeniy Paltsev Signed-off-by: Vineet Gupta

ARC: build: remove deprecated toggle for arc700 builds

2020-06-16T22:14:50+00:00

Signed-off-by: Vineet Gupta

ARC: build: allow users to specify -mcpu

2020-06-16T22:07:23+00:00

kernel build system used to add -mcpu for each ARC ISA as default. These days there are versions and varaints of ARC HS cores some of which have specific -mcpu options to fine tune / optimize generated code. So allow users/external build systems to specify their own -mcpu This will be used in future patches for HSDK-4xD board support which uses specific -mcpu to utilize dual issue scheduling of the core. Signed-off-by: Eugeniy Paltsev Signed-off-by: Vineet Gupta [abrodkin/vgupta: rewrote changelog]