kernel/git/stable/linux.git/arch/arm/boot, branch linux-6.7.y

arm: dts: marvell: Fix maxium->maxim typo in brownstone dts

2024-04-03T13:11:07+00:00

[ Upstream commit 831e0cd4f9ee15a4f02ae10b67e7fdc10eb2b4fc ] Fix an obvious spelling error in the PMIC compatible in the MMP2 Brownstone DTS file. Fixes: 58f1193e6210 ("mfd: max8925: Add dts") Cc: Signed-off-by: Duje Mihanović Reported-by: Krzysztof Kozlowski Closes: https://lore.kernel.org/linux-devicetree/1410884282-18041-1-git-send-email-k.kozlowski@samsung.com/ Reviewed-by: Andrew Lunn Link: https://lore.kernel.org/r/20240125-brownstone-typo-fix-v2-1-45bc48a0c81c@skole.hr [krzysztof: Just 10 years to take a patch, not bad! Rephrased commit msg] Signed-off-by: Krzysztof Kozlowski Signed-off-by: Sasha Levin

ARM: dts: imx6dl-yapp4: Move the internal switch PHYs under the switch node

2024-03-26T22:18:20+00:00

[ Upstream commit 79978bff2e4b8e05ebdf5fc3ee6b794002393484 ] We identified that the PHYs actually do not work since commit 7da7b84fee58 ("ARM: dts: imx6dl-yapp4: Move phy reset into switch node") as a coincidence of several circumstances. The reset signal is kept asserted by a pull-down resistor on the board unless it is deasserted by GPIO from the SoC. This is to keep the switch dead until it is configured properly by the kernel and user space. Prior to the referenced commit the switch was reset by the FEC driver and the reset GPIO was actively deasserted. The mdio-bus was scanned and the attached switch and its PHYs were found and configured. With the referenced commit the switch is reset by the qca8k driver. Because of another bug in the qca8k driver, functionality of the reset pin depends on its pre-kernel configuration. See commit c44fc98f0a8f ("net: dsa: qca8k: fix illegal usage of GPIO") The problem did not appear until we removed support for the switch and configuration of its reset pin from the bootloader. To fix that, properly describe the internal mdio-bus configuration of the qca8334 switch. The PHYs are internal to the switch and sit on its internal mdio-bus. Fixes: 7da7b84fee58 ("ARM: dts: imx6dl-yapp4: Move phy reset into switch node") Signed-off-by: Michal Vokáč Signed-off-by: Shawn Guo Signed-off-by: Sasha Levin

ARM: dts: imx6dl-yapp4: Fix typo in the QCA switch register address

2024-03-26T22:18:20+00:00

[ Upstream commit 023bd910d3ab735459f84b22bb99fb9e00bd9d76 ] This change does not have any functional effect. The switch works just fine without this patch as it has full access to all the addresses on the bus. This is simply a clean-up to set the node name address and reg address to the same value. Fixes: 15b43e497ffd ("ARM: dts: imx6dl-yapp4: Use correct pseudo PHY address for the switch") Signed-off-by: Michal Vokáč Reviewed-by: Andrew Lunn Signed-off-by: Shawn Guo Signed-off-by: Sasha Levin

ARM: dts: arm: realview: Fix development chip ROM compatible value

2024-03-26T22:18:16+00:00

[ Upstream commit 3baa4c5143d65ebab2de0d99a395e5f4f1f46608 ] When the development chip ROM was added, the "direct-mapped" compatible value was already obsolete. In addition, the device node lacked the accompanying "probe-type" property, causing the old physmap_of_core driver to fall back to trying all available probe types. Unfortunately this fallback was lost when the DT and pdata cases were merged. Fix this by using the modern "mtd-rom" compatible value instead. Fixes: 5c3f5edbe0a1dff3 ("ARM: realview: add flash devices to the PB1176 DTS") Fixes: 642b1e8dbed7bbbf ("mtd: maps: Merge physmap_of.c into physmap-core.c") Signed-off-by: Geert Uytterhoeven Signed-off-by: Linus Walleij Signed-off-by: Sasha Levin

ARM: dts: qcom: msm8974: correct qfprom node size

2024-03-26T22:18:13+00:00

[ Upstream commit 724c4bf0e4bf81dba77736afb93964c986c3c123 ] The qfprom actually is bigger than 0x1000, so adjust the reg. Note that the non-ECC-corrected qfprom can be found at 0xfc4b8000 (-0x4000). The current reg points to the ECC-corrected qfprom block which should have equivalent values at all offsets compared to the non-corrected version. [luca@z3ntu.xyz: extract to standalone patch and adjust for review comments] Fixes: c59ffb519357 ("arm: dts: msm8974: Add thermal zones, tsens and qfprom nodes") Signed-off-by: Craig Tatlor Signed-off-by: Luca Weiss Reviewed-by: Konrad Dybcio Link: https://lore.kernel.org/r/20240210-msm8974-qfprom-v3-1-26c424160334@z3ntu.xyz Signed-off-by: Bjorn Andersson Signed-off-by: Sasha Levin

ARM: dts: renesas: r8a73a4: Fix external clocks and clock rate

2024-03-26T22:18:03+00:00

[ Upstream commit 090c4094574705b0afc7d37825cdc5d06f0e7e02 ] External clocks should be defined as zero-Hz clocks in the SoC .dtsi, and overridden in the board .dts when present. Correct the clock rate of extal1 from 25 to 26 MHz, to match the crystal oscillator present on the APE6-EVM board. Fixes: a76809a329d6ebae ("ARM: shmobile: r8a73a4: Common clock framework DT description") Signed-off-by: Geert Uytterhoeven Reviewed-by: Niklas Söderlund Link: https://lore.kernel.org/r/1692bc8cd465d62168cbf110522ad62a7af3f606.1705315614.git.geert+renesas@glider.be Signed-off-by: Sasha Levin

ARM: dts: renesas: rcar-gen2: Add missing #interrupt-cells to DA9063 nodes

2024-03-26T22:17:53+00:00

[ Upstream commit 8c987693dc2d292d777f1be63cb35233049ae25e ] make dtbs_check W=2: arch/arm/boot/dts/renesas/r8a7790-lager.dts:444.11-458.5: Warning (interrupt_provider): /i2c-mux4/pmic@58: Missing '#interrupt-cells' in interrupt provider ... Fix this by adding the missing #interrupt-cells properties. Reported-by: Rob Herring Signed-off-by: Geert Uytterhoeven Reviewed-by: Rob Herring Link: https://lore.kernel.org/r/a351e503ea97fb1af68395843f513925ff1bdf26.1707922460.git.geert+renesas@glider.be Signed-off-by: Sasha Levin

arm: dts: Fix dtc interrupt_map warnings

2024-03-26T22:17:53+00:00

[ Upstream commit f02b0f0dc26fbb77fe47b6e47cc5c211f0432c37 ] The dtc interrupt_map warning is off because its dependency, interrupt_provider, is off by default. Fix all the warnings so it can be enabled. Signed-off-by: Rob Herring Reviewed-by: Linus Walleij Link: https://lore.kernel.org/r/20240213-arm-dt-cleanups-v1-4-f2dee1292525@kernel.org Signed-off-by: Arnd Bergmann Signed-off-by: Sasha Levin

arm: dts: Fix dtc interrupt_provider warnings

2024-03-26T22:17:53+00:00

[ Upstream commit 96fd598e9c34cfa68402a4da3020c9236cfacf35 ] The dtc interrupt_provider warning is off by default. Fix all the warnings so it can be enabled. Signed-off-by: Rob Herring Reviewed-by: Andrew Jeffery Reviewed-by: Alexandre Torgue Acked-by: Florian Fainelli #Broadcom Acked-by: Thierry Reding Link: https://lore.kernel.org/r/20240213-arm-dt-cleanups-v1-2-f2dee1292525@kernel.org Signed-off-by: Arnd Bergmann Signed-off-by: Sasha Levin

ARM: dts: rockchip: Drop interrupts property from pwm-rockchip nodes

2024-03-26T22:17:51+00:00

[ Upstream commit f98643d8daf3443e3b414a82d0cb3d745f8c8bbc ] The binding doesn't define interrupts and adding such a definition was refused because it's unclear how they should ever be used and the relevant registers are outside the PWM range. So drop them fixing several dtbs_check warnings like: arch/arm/boot/dts/rockchip/rv1108-elgin-r1.dtb: pwm@10280030: 'interrupts' does not match any of the regexes: 'pinctrl-[0-9]+' from schema $id: http://devicetree.org/schemas/pwm/pwm-rockchip.yaml# Signed-off-by: Uwe Kleine-König Link: https://lore.kernel.org/r/20240129113205.2453029-2-u.kleine-koenig@pengutronix.de Signed-off-by: Heiko Stuebner Signed-off-by: Sasha Levin