kernel/git/stable/linux.git/include/dt-bindings/pinctrl, branch linux-4.4.y

ARM: dts: Fix omap3 off mode pull defines

2017-11-21T08:21:19+00:00

[ Upstream commit d97556c8012015901a3ce77f46960078139cd79d ] We need to also have OFFPULLUDENABLE bit set to use the off mode pull values. Otherwise the line is pulled down internally if no external pull exists. This is has some documentation at: http://processors.wiki.ti.com/index.php/Optimizing_OMAP35x_and_AM/DM37x_OFF_mode_PAD_configuration Note that the value is still glitchy during off mode transitions as documented in spz319f.pdf "Advisory 1.45". It's best to use external pulls instead of relying on the internal ones for off mode and even then anything pulled up will get driven down momentarily on off mode restore for GPIO banks other than bank1. Signed-off-by: Tony Lindgren Signed-off-by: Sasha Levin Signed-off-by: Greg Kroah-Hartman

Merge tag 'pinctrl-v4.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

2015-09-04T17:22:09+00:00

Pull pin control updates from Linus Walleij: "This is the bulk of pin control changes for the v4.3 development cycle. Like with GPIO it's a lot of stuff. If my subsystems are any sign of the overall tempo of the kernel v4.3 will be a gigantic diff. [ It looks like 4.3 is calmer than 4.2 in most other subsystems, but we'll see - Linus ] Core changes: - It is possible configure groups in debugfs. - Consolidation of chained IRQ handler install/remove replacing all call sites where irq_set_handler_data() and irq_set_chained_handler() were done in succession with a combined call to irq_set_chained_handler_and_data(). This series was created by Thomas Gleixner after the problem was observed by Russell King. - Tglx also made another series of patches switching __irq_set_handler_locked() for irq_set_handler_locked() which is way cleaner. - Tglx also wrote a good bunch of patches to make use of irq_desc_get_xxx() accessors and avoid looking up irq_descs from IRQ numbers. The goal is to get rid of the irq number from the handlers in the IRQ flow which is nice. Driver feature enhancements: - Power management support for the SiRF SoC Atlas 7. - Power down support for the Qualcomm driver. - Intel Cherryview and Baytrail: switch drivers to use raw spinlocks in IRQ handlers to play nice with the realtime patch set. - Rework and new modes handling for Qualcomm SPMI-MPP. - Pinconf power source config for SH PFC. New drivers and subdrivers: - A new driver for Conexant Digicolor CX92755. - A new driver for UniPhier PH1-LD4, PH1-Pro4, PH1-sLD8, PH1-Pro5, ProXtream2 and PH1-LD6b SoC pin control support. - Reverse-egineered the S/PDIF settings for the Allwinner sun4i driver. - Support for Qualcomm Technologies QDF2xxx ARM64 SoCs - A new Freescale i.mx6ul subdriver. Cleanup: - Remove platform data support in a number of SH PFC subdrivers" * tag 'pinctrl-v4.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (95 commits) pinctrl: at91: fix null pointer dereference pinctrl: mediatek: Implement wake handler and suspend resume pinctrl: mediatek: Fix multiple registration issue. pinctrl: sh-pfc: r8a7794: add USB pin groups pinctrl: at91: Use generic irq_{request,release}_resources() pinctrl: cherryview: Use raw_spinlock for locking pinctrl: baytrail: Use raw_spinlock for locking pinctrl: imx6ul: Remove .owner field pinctrl: zynq: Fix typos in smc0_nand_grp and smc0_nor_grp pinctrl: sh-pfc: Implement pinconf power-source param for voltage switching clk: rockchip: add pclk_pd_pmu to the list of rk3288 critical clocks pinctrl: sun4i: add spdif to pin description. pinctrl: atlas7: clear ugly branch statements for pull and drivestrength pinctrl: baytrail: Serialize all register access pinctrl: baytrail: Drop FSF mailing address pinctrl: rockchip: only enable gpio clock when it setting pinctrl/mediatek: fix spelling mistake in dev_err error message pinctrl: cherryview: Serialize all register access pinctrl: UniPhier: PH1-Pro5: add I2C ch6 pin-mux setting pinctrl: nomadik: reflect current input value ...

ARM: dts: am43xx: Introduce MUX_MODE9 for pinctrl

2015-08-05T10:58:27+00:00

Some pins on AM43XX support MODE9 for the pinctrl settings so add a binding to describe this. Signed-off-by: Dave Gerlach Signed-off-by: Roger Quadros Signed-off-by: Tony Lindgren

pinctrl: qcom: ssbi: Family A gpio & mpp drivers

2015-07-17T19:56:14+00:00

This introduces pinctrl drivers for gpio and mpp blocks found in family A PMICs. Tested-by: Srinivas Kandagatla Signed-off-by: Bjorn Andersson Signed-off-by: Linus Walleij

pinctrl: dra: dt-bindings: Add virtual mode configuration option

2015-07-14T11:15:11+00:00

In addition to the regular mux configuration such as mux mode 1, 2 etc, certain pins of DRA7 require to have "virtual mode" also programmed. This allows for predefined delay characteristics to be used by the SoC to meet timing characterstics needed for the interface. Provide easy to use macro to do the same. It is important to note that the official TI guidelines recommend to do as minimal pin reconfiguration beyond the bootloader given the design of the hardware involved which can result in substantial glitches which may impair functionality of certain peripherals. Signed-off-by: Nishanth Menon Signed-off-by: Tony Lindgren

Merge tag 'armsoc-dt' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

2015-06-26T18:43:59+00:00

Pull ARM SoC DT updates from Kevin Hilman: "As usual, quite a few device-tree updates in ARM land. There was one minor churn in DTs due to relicensing under a dual-license, and lots of little additions of new peripherals, features etc, but nothing really exciting to call to your attention. Some higlights, focsuing on support for new SoCs and boards: - AT91: new boards: Overkiz, Acme Systems' Arietta G25 - tegra: HDA support - bcm: new platforms: Buffalo WXR-1900DHP, SmartRG SR400ac, ASUS RT-AC87U - mvebu: new platforms: Compulab CM-A510, Armada 385-based Linksys boards, DLink DNS-327L - OMAP: new platforms: Baltos IR5221, LogicPD Torpedo, Toby-Churchill SL50 - ARM: added support for Juno r1 board - sunxi: A33 SoC support; new boards: A23 EVB, SinA33, GA10H-A33, Mele A1000G - imx: i.MX7D SoC support; new boards: Armadeus Systems APF6, Gateworks GW5510, and aristainetos2 boards - hisilicon: hi6220 SoC support; new boards: 96boards hikey" * tag 'armsoc-dt' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (462 commits) ARM: hisi: revert changes from hisi/hip04-dt branch ARM: nomadik: set proper compatible for accelerometer ARM64: juno: add GPIO keys ARM: at91/dt: sama5d4: fix dma conf for aes, sha and tdes nodes ARM: dts: Introduce STM32F429 MCU ARM: socfpga: dts: enable ethernet for Arria10 devkit ARM: dts: k2l: fix the netcp range size ARM: dts: k2e: fix the netcp range size ARM: dts: k2hk: fix the netcp range size ARM: dts: k2l-evm: Add device bindings for netcp driver ARM: dts: k2e-evm: Add device bindings for netcp driver ARM: dts: k2hk-evm: Add device bindings for netcp driver ARM: BCM5301X: Add DT for Asus RT-AC87U ARM: BCM5301X: add IRQ numbers for PCIe controller ARM: BCM5301X: add NAND flash chip description arm64: dts: Add dts files for Hisilicon Hi6220 SoC clk: hi6220: Document devicetree bindings for hi6220 clock arm64: hi6220: Document devicetree bindings for Hisilicon hi6220 SoC ARM: at91/dt: sama5d4ek: mci0 uses slot 0 ARM: at91/dt: kizbox: fix mismatch LED PWM device ...

Merge tag 'omap-for-v4.2/dt-pt1' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap into next/dt

2015-05-28T20:41:13+00:00

Merge "Device tree related changes for omaps" from Tony Lindgren: - Configure MMC data lines 4..8 for 1.8V IO on boards that are using them as GPIOs instead of MMC data lines - Add support for Baltos IR5221 - Add device tree support for LogicPD Torpedo devkit - Add 3717 core pinctrl region - Add gta04 1w and GSM audio support - Add wilink and ov2659 support for am437x-gp-evm - Add am335x-evm bluetooth and mmc3 support - Enable omap5-uevm uart wakeup interrupt - Enable I2C2 on BeagleBone as it's used for the capes - Use defines for LDP GPIO keys * tag 'omap-for-v4.2/dt-pt1' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap: ARM: dts: am335x-evm: add mmc3 and wlan definitions to dts ARM: dts: Enable SDIO card interrupt for 37xx-evm ARM: dts: Fix ldp gpio keys to use defines ARM: dts: Beaglebone i2c definitions ARM: dts: am437x-gp-evm: add DT nodes for ov2659 sensor ARM: dts: add DTS for Baltos IR5221 ARM: dts: omap5-uevm: Add Uart wakeup interrupt ARM: dts: omap3-gta04: Add GSM audio support ARM: dts: am335x-evm: add bluetooth support ARM: dts: am437x-gp-evm: add wilink8 support ARM: dts: omap3-gta04: Add hdqw1 support ARM: dts: add core2 padconf region for am3517 ARM: dts: Add minimal support for LogicPD Torpedo DM3730 devkit ARM: OMAP3: Add support for configuring MMC pins as GPIO pins

ARM: dts: am437x-gp-evm: add wilink8 support

2015-05-20T17:53:18+00:00

enable mmc3 used for wlan and uart3 used for bluetooth configure the gpios used for wlan and bluetooth controls add fixed voltage regulator used for wlan power control Signed-off-by: Eyal Reizer Signed-off-by: Tony Lindgren

pinctrl: mt6397: Add pinfunc header file for mt6397.

2015-05-19T09:11:34+00:00

Add pinfunc header file, mt8135/mt8173 relate dts will include it. Signed-off-by: Hongzhou Yang Signed-off-by: Linus Walleij

ARM: bcm2835: dt: Add header file for pinctrl constants

2015-05-14T09:02:31+00:00

This new header file defines pincontrol constants to use from bcm2835 DTS files for pincontrol properties option. Reviewed-by: Stephen Warren Signed-off-by: Stefan Wahren Signed-off-by: Lee Jones